PLA first-layer test log for a PEI plate

A reusable bench sheet from PrintTuned.

Start with one PLA spool, one printer and one PEI plate. Keep the patch and its slicer settings consistent so you can see what changed before committing to a full print.

Setup · Printer __________ · Nozzle __________ · PLA and lot __________

Plate · Exact model and side __________ · Selected slicer profile __________

Baseline · Bed and nozzle settings __________ · First-layer speed __________

Capture a usable baseline

  1. Slice a small flat one-layer patch. Note its location and confirm that the slicer profile matches the printer, material and plate.
  2. With the machine stopped and cool enough to handle, check that a removable sheet is fully seated and clear underneath. Prepare the surface as the plate maker directs.
  3. Watch the perimeter and neighboring lines. If the patch comes loose, stop with the printer controls. Record the first visible symptom and where it happened.

Choose one retest

  • Lines stay separate. Follow the printer’s first-layer calibration procedure. If line width varies too, check feed consistency before adjusting nozzle distance.
  • Lines join on one side and lift on the other. Repeat the same patch at another suitable position using the same settings. Does the symptom follow the position?
  • The nozzle drags through ridges. Stop and verify the selected plate profile, calibration and extrusion settings before rerunning.
  • An edge lifts after a flat start. Record when the edge lifted and where. Check this separately from squish or gaps in the first lines.

Keep the comparison

Run Patch location One change Perimeter and fill Outcome
Baseline ______ — ______ ______
Retest A ______ ______ ______ ______
Retest B ______ ______ ______ ______

Label a photo or the patch with the plate side and run number. Once the perimeter and fill hold, consider repeating the patch over the footprint of the actual part before starting a long print.

Use PrintTuned’s illustrated guide to PLA first layers on PEI to compare the gaps, ridges and location-specific peeling in your log.

Tags: 3D printing